Everyone in the use of touch screen control touch screen board classroom in the all-in-one or industrial integration, frequently touch screen response is not sensitive or can't touch. This is what causes, industrial control fault is mainly due to touch touch screen machine Settings or hardware problems caused by the touch of the following is a general industrial control touch screen machine sharing and solve the problem
1, By finger touch position did not overlap with the mouse arrow. 65 inch smart board This kind of phenomenon is mainly after installing the driver, in the correct position, there is no vertical touch bull 's-eye center position.
Solution: to correct position. After installing the driver for the correction for the first time, pay attention to the details of the observation system error. Didn't find control card, touch screen is not connected, etc., according to the prompt to check the corresponding parts.
2, Industrial control area of the touch screen machine touch accurately, area of the touch have deviation.
This kind of phenomenon is a touchscreen acoustic 65 inch touch screen reflection stripes above accumulated a large amount of dust or scale, caused by the effect of acoustic signal transmission. The solution: clean the touch screen, touch screen will pay special attention to the 4 acoustic reflection stripe is clean, clean the touch screen control card should be power off.
3 touch screen, touch screen control in the machine operation, but the computer can not work normally when the host is connected, the computer can't operate.
Solution: according to the analysis of the reasons are: it could be control in industrial control touch screen all-in-one touch screen driver version is too low, you need to install the latest drivers. May also be in the host start loading control in industrial control touch screen before all-in-one touch screen driver, industrial touch screen control in the all-in-one touch screen control card receives the operation, just after power again, restart the computer.
4, Touch not: a surface acoustic wave touch screen, industrial touch touch screen whiteboard screen machine control in the fingers touch display screen part is not completed properly the corresponding operation. Solution: according to the analysis of the reasons are: may be a reflection of acoustic screen stripe have been damaged, if you encounter this kind of situation will not be able to fully repair; Touch screen may also be a touch screen control in the machine in use after a period of time, the reflection stripe around the screen is covered by dust above, use a dry soft cloth to wipe, then power, restart the computer and recalibrate.
5, Touch screen no response, industrial control, touch screen smart board touch screen machine, according to touch any part have no response.
Solution: first check all wiring interface become loose, then check that the serial port and interrupt number if there is a conflict, if it is caused by the conflict, so should adjust resources, avoid conflict. Second, check whether industrial touch screen all-in-one control in the touch screen surface cracks, such as found cracks, it should be replaced in a timely manner. In addition, you also need to check whether there is all-in-one touch screen control in industrial control touch screen surface dirt, if any, with a soft cloth to clean. Observation to check if the indicator lights on the control box operates normally, normal, the light is green, and shine. If the above parts are normal, can be used to replace method to check the touch screen, touch screen machine control in the industrial automation to replace the control box, then replace the touch screen, eventually replace the host.