Connect HP Printer Using WPS Pin

Question

• Go to the manage panel of your HP Printer and then after urgent the Wireless button, go to the Settings.
• After touching on the WiFi Protected Setup, you ought to observe the prompts acting on the screen.
• Now you will be caused to PIN, faucet on this PIN. When you do so, WPS PIN will be displayed on the screen.
• The next step is to get entry to the configuration utility or the software program for the wi-fi gets entry to factor or wi-fi router. After this, you will have to enter your WPS PIN.
• After the completion of setup, in All Programs, open the HP Folder of the Printer. Then, go to the Printer Setup and Software. Then, pick the alternative of “Connect a New Printer”. This way, you can effortlessly set up the Network Printer Driver.
• Congratulation WPS Pin has been generated and your HP Printer is linked wirelessly with your home windows 10 computer.
• wps pin hp printer

Answer 1

1. Place the printer and the computer or mobile device near the Wi-Fi router.

2. Put the printer in WPS connection mode.

• Most printers with a touchscreen control panel: Open the Setup, Network, or Wireless settings menu, select Wi-Fi Protected Setup, select Push Button, and then select Start.
• Most printers without a touchscreen control panel: Press and hold the Wireless button for five seconds or until the wireless light starts to flash.
• HP Deskjet 6000 and 6400, ENVY 6000 and 6400, and Tango printers: Press and hold the Wi-Fi button and the Power button on the back of the printer for five seconds until the blue bar flashes.

3. Within two minutes, press and hold the WPS button on the router for three to five seconds, or until the connection process begins.

4. Return to the printer and check the status of the wireless light or bar.

• If the light or blue bar stops flashing, the printer is successfully connected to the network. Go to 123.hp.com to install the HP software to complete the connection to your computer or mobile device. For Chromebooks, go to HP printer setup (Chromebook).
• If the light or blue bar is still flashing or turned off, the connection failed. Continue to the next step.

5. Restore Wi-Fi setup mode.

• Most printers with a touchscreen display or menu: Open the Wireless or Setup menu, select Network setup or Settings, and then select Restore Network Settings.
• Printers without a touchscreen display or menu: Go to Restore Wi-Fi setup mode on your HP printer to restore default settings by pressing the buttons on your printer.

6. Repeat the steps to put the printer and router in WPS mode to complete the connection.

Hope This Works,
Peter