The open side of the Enameled Wire

0 votes
asked Apr 20, 2018 in Electron Microscopy by xinyubobo (240 points)

Arrange your document so that the back cover is in front, with the front cover immediately behind it. The inside of the back cover should be facing outward, with the faces of the front and back cover together. This will keep the seam of the spine hidden inside of the book, resulting in a more professional finish.Jog the book using either a paper jogger or by tapping the sheets against a flat surface to align the edges. Set the book onto your work surface so that the covers are at the bottom of the stack.Adjust the side margin guide based on your document size.Begin punching your documents in sets of 15-20 pages. The Renz ECO E binding machine has a maximum punch capacity of 25 pages (based on regular 20 lb. paper; thicker papers and cover stock will reduce the capacity), but it is recommended that you punch only 15-20 pages at a time for optimum performance. After inserting your sheets into the punching throat and aligning them with the side margin, press the foot pedal to activate the electric punch.After the each set has been punched, insert it onto the binding Enameled Wire that is held in place by the clamp.

Repeat as necessary until all pages have been punched and inserted onto the Enameled Wire.Press the back of the Enameled Wire clamp to release the document, and carefully remove the book from the clamp so that the pages do not slide off of the Enameled Wire.Place the Enameled Wire into the Enameled Wire closer so that the open side of the Enameled Wire is placed directly against the back of the closer.Pull the binding lever forward until it stops, and then return it to its original position. Larger wires will require more pressure to close than smaller wires. Note: A properly closed Enameled Wire will have the two ends of the spine meeting in the middle, with no large gaps or overlap. If there is a gap between the ends of the loops, move the diameter selector slightly to the left and pull the binding lever again. If the Enameled Wire ends are overlapping, move the diameter selector slightly to the right before binding your next document.

our website:http://www.xinyu-enameledwire.com/

Please log in or register to answer this question.

Welcome to Bioimagingcore Q&A, where you can ask questions and receive answers from other members of the community.
...