Flotation Machine driven by the triangle motor drive impeller rotation, resulting in the formation of negative pressure centrifugal, on the one hand, inhalation of sufficient air and pulp mixing, on the one hand mixing pulp and drug mixing, while the refinement of the foam, the mineral foam bonding, Float to the mineral surface and then form a mineralized foam. Adjust the ram height to control the fluid level so that the useful foam is scraped off by the scraper.
Shin Kong Machinery production of flotation equipment has the following characteristics: Inspiratory capacity, low power consumption. Each slot combines suction, suction and flotation triple functions, since the flotation circuit, without any auxiliary equipment, horizontal configuration, easy to process changes. Pulp circulation is reasonable, can minimize the precipitation of coarse sand. Self-control device with pulp surface, easy to adjust. Impeller with a sloping up and down leaves. Pulp on the leaves produced on the pulp circulation, under the pulp to produce pulp under the cycle.
Flotation Equipment goldenmachine work, with the rotation of the impeller, the tank slurry from the bottom through the bottom of the impeller from the bottom sucked impeller blades, at the same time, by the blower into the low-pressure air through the hollow shaft and the impeller air distributor, also Into it. Pulp and air after the full mixing between the leaves, the impeller from the upper half of the ramp to the upper pushed by the steady flow and orientation of the stator into the entire tank. Bubbles rise to the foam stability zone, after the enrichment process, the foam overflows from overflow weir, into the foam tank. There is also a part of the pulp flow to the lower part of the impeller, and then stirred by the impeller, re-mixed to form mineralized bubbles, the remaining pulp flow to the next slot, until eventually become tailings.