Quick Details
Place of Origin: Hangzhou, China
Cartridge filter housing material: 304ss or 316L
Pressure of equipment: 0.6-1.6MPa
Filtration accuracy: 1μm ~ 100μm
Cartridge filter housing Length: 10 "~ 40"
Operating temperature: 5 ~ 40 ℃ (exceed 60 ℃ to be informed)
Cartridge Quantity: 1 core to 180 cores
Design temperature: 5 ℃ -100 ℃
Replace the pressure: 0.05Mpa-0.07MPA
Cartridge filter housing Seal type: O-ring or flat washer
Install instruction
1. Please clean filter shell carefully before using.
2. Connect cartridge filter with other in-line filtering system. Please check inlet and outlet install direction.
3. Open the filter top cover to check cartridge condition: O-ring’s sealing and its position.
4. Users can use wetting agent (Water e.g) to wet O-ring and cartridge socket.
5. Hold the cartridge near O-ring side, insert it into socket vertically.
6. Insert all cartridges, fixing with press plate and covering with top cover.
Open vent valve at the top of out shell. Turn on inlet valve a bit, let liquid into shell. Turn off vent valve till liquid comes into shell entirely and leak from vent valve. Adjust outlet valve gradually until turn on it fully. Turn on inlet valve slowly to adjust pressure drop to a data of 0.02MPa.
Notes in operation
1. Avoid pressure impact, reverse pressure is forbidden.
2. Replace cartridge when differential drop is big than 0.3MPa, or flow rate down obviously.
3. If filter no need work for a short time, soak cartridge in sterile solution, but don’t dry cartridge. User can pour sterile solution inside filter house, clean it before again use.
4. If users need steam sterilization for filter, make sure drain condense water, and steam pressure not exceed 0.1MPa, filter differential pressure not exceed 0.015MPa.
If users need disinfect wet cartridge, please use clean compress air absorb all liquid, or else, steam will destroy cartridge.
https://www.rywatertreatmen.com/cartridge-filter-housing/ss-304-316-316l-industrial-stainless-steel.html